Q: Needle wont take under bobbin thread
A: Check upper and lower bobbin is threaded properly, rethread and try again. If problem persists clean under bobbin casing, if no joy possible sensor fault, it can be disabled but will void warranty.
Q: The needle keeps breaking
A: The needle maight be bent or blunt, The needle clamp may be loose, The needle is incorrectly installed but i think this is very unlikly but it is always best to check. The upper thread tension is to tight try reajusting the tension,The spool is incorrectly installed, The area around the hole on the plate itself is scratched or as a burr on it, The bobbin case is damaged or as a burr on itor using the wrong bobbin for the maching.
Q: The upper thread keeps breaking
A: There are knots or tangles in the thread, The upper thread tension is to tight, The needle is bent or blunt in somecases these are bought not relising that they are bent
Q: The lower thread is tangled or may even break
A: The bobbin thread is incorrectly installed, The bobbin is scratched or wont rotate properly, The thread is tangled.
Q: An high pitch noise is made while embroidering
A: Dust or dirt as over time as accumulated in the bobbin case, You could even be using the wrong bobbin.
Q: Stitches keep skipping
A: The upper thread proberly is not threaded properly rethread and try again, The needle is blunt, Dust or dirt has accumulated in the bobbin case just taske out a nd give a general clean.
Q: The stitch is not sewing correctly
A: The thread tension is proberly set to high reset thread tension and try again, The thread is tangled in the bobbin,
Q: Embroidery is not neatly done
A: The fabric you are using is not stretched in the embroidery frame and the fabric may be to loose, Not using the right or even enough backing paper or none at all, The thread tension may be set wrong for the fabric you are useing, The fabric is catching, The fabric is an heavy material and is hanging down over the bench.
Free Embroidery Designs